Products by car model: Hardware & tools

Brake piston tool, dimension of 0-65 mm

The brake pipe clamps 1/4 ", 3/16", 4.75 mm and 6 mm pipes

Pen shaped test tool, which is easy to check whether the brake fluid accumulated in the water. Shockproof design. Made with the relevant EU Directive. Intended for two types of DOT, DOT 3, DOT 4 May diode detector. Powered by 1 x 1.5V AAA. The brake fluid tester measures the brake fluid boiling point.

Brake shoe springs for installation and removal.

Screw Clamp, 1/2 "hole, 21 mm base, up to 230 mm

Perfect for general-purpose spring tensioner all McPherson spring struts. A maximum load of 3.8 tons. 3 different spring clamp pairs, distance 300 mm.2 pieces of the spring retainer 110 mm 2 pieces of the spring retainer 150 mm 2 pieces of the spring retainer 195 mm 1 pcs spring tensioner 453 mm 1 adapter

General purpose puller for ball joints, etc. Wingspan 19 mm.

Wedge shaped release fork ball joints. Aperture 20 mm

Wedge shaped release fork for ball joints. Aperture 24 mm

General purpose puller for ball joints

Universal crimping tool kit bearings, bushings and shaft seals to remove and install. Connectors can be used in the repair shop presses.

A handy little camber gauge which attaches to a brake disc with a magnet.Measures +- 6 degree of camber and has a calibrating knob as well.This gauge comes in it's own box, weighing less than a kilo. This is a very handy tool to have on track days and garages.

Sonax microfiber towels for gentle interior and exterior cleaning.

Hex female flush-fit steel wheel nuts. Really small hex female wheel nuts which allows you to safely bolt without scratching the wheels.

Stainless steel hose clamps for fuel hoses and similar applications. These are the OE type quality fasteners with rounded corners and good threads.

Thermo Tec heat shielding stickers is a cost-effective and easy to use product to shield engine bay parts from starters and solenoids to brake fluid reservoirs from heat.

The Thermo Tec heat shielding tube protects wires and hoses from labda wires and turbo oil feeds to intake pipes which run close to the exhaust manifold. Length 90 cm.

The Snow Foam Lance makes washing your ride quick, easy and thorough with minimal wear on the paintwork. Includes a 7-piece adapter set.

Maximum comfort and control for even coverage of polishes and dressings

A super absorbent and hard wearing synthetic chamois that replaces your traditional leather, for use inside and out.

Hi-Tech polish applicator for easier waxing and less effort.

Microfibre wash glove for gentle car wash

Excellent choice for example Japan Racing wheels. Some of the models cant use normal wheel nuts due to too large diameter. Length 35-45mm.

With Gates hose reducer you can mount different size hose without problems.